Reconnecting your Sol-Ark to wifi after password change

Video for guide to connect wifi dongle to network HERE.

1. On a Smart Phone or Computer, connect to the EAP-##### network.

You can do this by going to: 

• Settings>Wi-Fi, select the EAP-##### network.
• Password= 12345678. 
• The EAP-##### network contains the last 5 digits of the Dongle serial number.
• You can find this number on the dongle label.

2. A message such as “Connected without internet” appears when the device is connected to the EAP-#####.

3. Once connected, open an internet browser on that same device such as Safari, Chrome, Firefox, Edge, or any other browser.

4. On the address bar (http://.........),type the IP address: 10.10.10.1 as shown in the figure below. If you cannot access the configuration page, try again on a different device.

5. Scroll down to the Wlan Connection section and tap the Scan button to scan for local Wi-Fi networks.

6. Nearby Wi-Fi networks will appear. Select the local network you would like to connect to, input your credentials, and tapConnect

7. Once connected, a “Connection Successful” message appears. Tap the Save button next to Scan to save settings.

8. Wait a few minutes. The dongle will connect to the Wi-Fi network, and you’ll now have access toMySolArk

Note:DO NOT connect to theEAP-#####network, as that is the Wi-Fi dongle itself. The device does not provide internet access